So I was able to convert UOP to MUL with Legacy converter just fine.
I replaced 2081 and 2082 (Journal gumps)
When I run
LegacyMULCL.exe -x C:\LegacyConverter\Mul <----- Thats where my edited MUL files are, I get the following message
All actions completed sucessfully
Thing is, I don't have UOP files
What did I do wrong?
Legacy converter - MUL back to UOP issue
- Supercreep
- Posts: 242
Re: Legacy converter - MUL back to UOP issue
Figured this out ten seconds after posting this.
Dumb mistake. While converting them back, I left the -x in.
Removed that and all is well. Command should have been
LegacyMULCL.exe C:\LegacyConverter\Mul
Thanks!
Dumb mistake. While converting them back, I left the -x in.
Removed that and all is well. Command should have been
LegacyMULCL.exe C:\LegacyConverter\Mul
Thanks!